checking node failure

Free domotica! › Forums › Report a bug › checking node failure

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • November 5, 2015 at 10:16 pm #1666
    AvatarMaybe
    Participant

    In the z-wave service the node failure check never returns a failure nor an OK

    November 6, 2015 at 7:33 am #1668
    MikaMika
    Keymaster

    This functionnality is just an “Nice To Have” option, it can give you eventually information about your device.

    You have to know that the “Node Failded” is one of the most complex functionality of the OpenZwave library.
    I added that information to give informations….

    November 6, 2015 at 11:19 pm #1681
    AvatarMaybe
    Participant

    And how do I know the device is added and configured correctly?
    For instance I only see one node for my ALMS, I suppose it is the motion sensor but where do I find the lux, temp and humidity sensor?

    November 7, 2015 at 7:22 am #1691
    MikaMika
    Keymaster

    If you edit your device, on the first page, you’ll see the status.
    If it’s complete => Everything is OK
    If not, you may have a problem.

    I’ll release the new version of the zwave service soon, so maybe wait for that version to see if your problem is solved.

    November 7, 2015 at 9:52 am #1699
    AvatarMaybe
    Participant

    I’ll try to be patience 😉

    November 14, 2015 at 7:00 am #1752
    MikaMika
    Keymaster

    In the new version of the zwave service, you have a button “Test node” when you edit a device.

    If your device is marked as “Probe” or “Node Failed”, you can click on that button.
    It will try to restore the communication between your controller and your device.

    IMPORTANT : If your device have battery, be sure that he is wake up!

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.