My Motion sensor Fibaro sensor FGMS-001 is detected in the list of zwaves devices as Routing Binary Sensor, but it is not recognized (no product information detected neither access to properties). So I cannot use this device.
I used pulse-station on Synology platform and I am using a Aeon Z-Stick S2 controller. I tried to remove and pair this device many times, but always the same result.
Sometimes it needs a long time until the “Product” is updated.
Really long time…
I had the same problems with other Fibaro products…
Or try restart the “Core” and “Zwave” Service.
Finally it should work and should say “FGMS001 Motion Sensor”
You can try to clear the config files inside the zwave controller commands.
Then sometimes it redetects it properly.
It’s not PulseStation doing this, but the openzwave library they are using.
Nothing that can be done against it 🙁
Also make certain the association to node-001 is correctly set-up.
Finally I found a solution… maybe not the best one, but it works for me ! I simply woke up the Fibaro sensor several times by clicking 3 times on the B button… and the node was activated !
Now I can drive my sensor properties and use it in my network.
I`ve got a new device FGMS001 with type=”0801″ id=”1001″.
I already pasted a new line in the manufacturer_specific.xml, but it doesn`t work 🙁
Difference to the “old” one: in Pulsestation it`s a “notification sensor”. The old was discovered as an “Routing Binary Sensor”.