I’ve installed the Imperihome app on my iPhone. And adding the Imperihome Standard System works. It even does it without supplying my login and password. Is that correct?
Then I want to add my GreenWave Powernodes. However, when I want to add it to my Dashboard by choosing a device widget, it doesn’t show any devices. How do I solve this?
For android imperihome should only work when you provide credentials.
Very strange, we will investigate this.
Do you see the greenwave devices in the list of devices inside imperihome?
(Do a refresh first).
If not: inside pulsestation, in advanced settings of imperihome, you can choose to send more devices to Imperihome.
I thought it was strange that I could just connect to the service on iOS without my credentials. Just let us know what you find out.
I got it working. I didn’t provide a name for the device on the Zwave service page. As soon as I did that it started working. However, when I add a location on that page, it disappears from the ImperiHome again. Should it do that?
You’re right, it appeared on a different page. I do have a lot of empty pages though in list view from Imperihome. Why does Pulsestation create those? I just have 2 switches, 2 camera’s, a controller, yahoo weather service and a scene (blocky) running. In Imperihome I start with three empty pages, than one camera (setup as a different system), the weather, an empty page, the 2 switches on 1 page, and finally the blockly on 1 page. Are the three pages the controller and the 2 virtual devices (camera’s)? What is the fourth page then?
I added for all devices a location. In PulseStation dashboard interface it shows correctly. All locations are displayed with the correct devices. In Perihome however I still see various empty pages in list view. All locations are mentioned including extra because of the camera system which was added separately.
