Hey,
I have added a new Roller Shutter but obviously it was out of range (Node007). It was correctly labeled as Motor Control Class B but it didn’t work (Node is failed).
I removed the hardware and installed it with a different motor (closer to other zwave nodes). In Pulsestation, nothing changed. So I removed the Node from my controller and added it again. In the logfile I can see that a new Node008 was found and added to the system.
When I look at the PulseStation administration panel under Services/Z-Wave, I still have zwave-7 as a Motor Control Class B, that doesn’t show the correct properties, status says ControllerState_NodeOk.
What can I do to remove my Phantom Node007 and get Node008 into the configuration tool?
Thank you!