Hi,
So, my ZW FB 10 remote control from duwi is working. 🙂
BUT:
I can not control anything inside PulseStation with it.
Eg: I cannot start PulseStation scenes or trigger rules.
We’ll see whether we can add this.
What can I do?
1) I can see the device inside PulseStation.
I have added it by:
PulseStation services / z-wave / controller commands / add device
Once PulseStation it’s listening for devices, hold the Include button of the remote for 2 seconds.
2) I can link the 10 on / status / off group buttons to individual devices.
I first press 3 times quickly the up button on the remote, so that the light keeps flashing.
Then I put the device I want to control into the include mode.
Fibaro: press 3 times very quickly the on/off button
Swiid: press for 1 or 2 seconds the small white button at the back
So agreed, it’s not perfect, but I can use it to control my house.
I think it even uses the entire mesh network of my house to extend the signal, via the PulseStation main controller, but not certain about that, to be verified.
I’ve added the device into the store:
https://www.pulse-station.com/products-page/accessories/z-wave-zme-controlscene-remote-control-2/
-
This reply was modified 5 years, 4 months ago by
K.Rens.