[Support request] Wrong RPi installation instructions

Free domotica! Forums Report a bug Wrong RPi installation instructions

Tagged: ,

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #3356

    I was trying to install Pulse-Station in a Raspberry Pi 2 with a uSD 32GB by following the steps in https://www.pulse-station.com/ufaqs/how-to-install-on-raspberry-pi/

    I found that this page is out of date, it doesn’t work and it is a little bit confuse. Just to resume my process, I include the steps that worked fine:

    1) Install Raspbian system on your RPi by using NOOBS as the instructions in https://www.raspberrypi.org/help/noobs-setup/ says. It is more convenient to use the NOOBS method, instead to use directly the Raspbian image, in order to take advantage of all the uSD capacity without any tweak.

    2) After the image has been burned to the SD card, safely remove it from your computer and insert it in the Raspberry Pi. Power it on and wait till it’s booted.

    3) From a terminal (first time, since maybe you don’t know the assigned IP, I recommend to access directly with a monitor and a keyboard/mouse), execute the following:

    sudo apt-get update && sudo apt-get upgrade
    sudo wget -O - https://pulse-station.com/app/rpi-install.sh | sudo bash

    4) You can now open PulseStation in your browser:
    Front-end: http://IP-OF-YOUR-RASPBERRY-PI/PulseStation/
    Admin: http://IP-OF-YOUR-RASPBERRY-PI/PulseStation/administration/

    You can find the IP-OF-YOU-RASPBERRY-PI in the router logs or by using the command ifconfig from a terminal in the RPi.

    You can now login with following credentials:
    Login: admin
    Password: admin


    Tx, merged both instructions together to make it easier!

    Kind regards,

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.