Répondre à : Trouble including the Fibaro Smoke Sensor

[coldbringer]

Hey Mika,

thanks for your reply. I woke up the device, now I get the following information: Status: WakeUp. Is the node failed? ControllerState_NodeOK. But still, when I switch from General tab to Properties Tab, the page is blank. No chance of changing the smoke sensor’s parameters.

You wrote:
“The type of your device comes from the OpenZwave library, if you have all the needed properties, it’s the principal.” Unfortunately, I have no idea what that means. Please explain.

Is there a guide about how to add a Smoke Sensor / Temperature Sensor to ImperiHome manually? The Imperihome website is not very helpful.

Many thanks