How to force routing table calculation

Domotica gratuit Forums Protocol-specific Z-Wave (plus) How to force routing table calculation

Ce sujet a 3 réponses, 3 participants et a été mis à jour par  AlainChofardet, il y a 1 an et 8 mois.

4 sujets de 1 à 4 (sur un total de 4)
  • Auteur
    Messages
  • #2342

    AlainChofardet
    Participant

    Hi.
    I’m quite new to zwave things.
    I’ve build a network with around 30 devices.
    As I encounter some communication problems, I had a close look to the “zwave” log. When the software starts, I can find that the controller asks each node for its routing table (who are your neighbours ?).

    So I build a little exhaustive sheet with the results and I can see that the table is completely mad. It needs to be recalculated.

    Is there a way to launch such a process ?

    #2348

    K.Rens
    Admin bbPress

    If you have the latest version installed of the zwave service, (see software update inside administration panel), then inside the controller commands there is a button to rediscover the neighbours of your devices.

    Kind regards,
    K.Rens

    #2349
    Mika
    Mika
    Admin bbPress

    For the moment this functionnality is only available for beta tester.
    Need a next release to be available for everyone.

    #2350

    AlainChofardet
    Participant

    OK. Thanks for the replies

4 sujets de 1 à 4 (sur un total de 4)

Vous devez être connecté pour répondre à ce sujet.