Phantom Node

Domotica gratuit Forums Report a bug Phantom Node

Ce sujet a 2 réponses, 2 participants et a été mis à jour par  coldbringer, il y a 2 ans et 1 mois.

3 sujets de 1 à 3 (sur un total de 3)
  • Auteur
    Messages
  • #1396

    coldbringer
    Participant

    Hey,

    I have added a new Roller Shutter but obviously it was out of range (Node007). It was correctly labeled as Motor Control Class B but it didn’t work (Node is failed).

    I removed the hardware and installed it with a different motor (closer to other zwave nodes). In Pulsestation, nothing changed. So I removed the Node from my controller and added it again. In the logfile I can see that a new Node008 was found and added to the system.

    When I look at the PulseStation administration panel under Services/Z-Wave, I still have zwave-7 as a Motor Control Class B, that doesn’t show the correct properties, status says ControllerState_NodeOk.

    What can I do to remove my Phantom Node007 and get Node008 into the configuration tool?

    Thank you!

    #1398
    Mika
    Mika
    Admin bbPress

    Use the “Controller Commands” button and try to remove config files.
    It will restart the service and re-generate the files…

    #1401

    coldbringer
    Participant

    That worked, thanks.

3 sujets de 1 à 3 (sur un total de 3)

Vous devez être connecté pour répondre à ce sujet.