januari 21, 2016 om 3:20 pm #2507
I have the issue that my heating device lost the node to the remote after 10 seconds.
I also use the ImperiHome App on my Smartphone. There can I see all my devices and I get also the current temperature of all rooms. But I can’t set the temperature of the devices. After 3 seconds they fall back to the default value “0”.
In the next hours I will sent you the .xml and .json file
Thanks for your help!!!januari 31, 2016 om 1:31 am #2582
Did you send the files?
If it is battery powered, it could be that it takes till the wake-up of the device untill the parameters are updated.
K.Rensjanuari 31, 2016 om 1:26 pm #2584
yes I send it to the e-mail address info(at)pulse-station.com.
Please contact Mikael G. he wrote me yesterday, that he will take a look soon.
But if you want, I can sent you the e-mail twice to another adress.
cheersjanuari 31, 2016 om 1:33 pm #2585
No, if Mikael is looking at it, it’s fine.
K.Rensjanuari 31, 2016 om 1:47 pm #2587
yes the devices are battery powered.
If I go to the device settings in the “z-wave services” I can see a lot of – default – setting values, but if I want to change it, the devices fall back to the default value same like in the ImperiHome app. I guesss that the PulseStation – software don’t accept my changes and save my entries because of the node connection failure, it’s not a failure with the wake-up feature. I also guess that beacause of the node failure only a half of functionalities are actice. I can see the settings of the device and can see the current temperature, but I can’t sent commands to the device – only a one way connection.
januari 31, 2016 om 1:55 pm #2589
- Deze reactie is gewijzigd 4 jaren, 10 maanden geleden door MrMorgan.
Is the device associated to the zwave-1 key?
What you can try is:
wake up device, wait 15 seconds, wake it up again
refresh PulseStation and verify whether the parameter is updated or not.
If not, it’s probably not yet supported and needs to be added.
K.Rensjanuari 31, 2016 om 2:35 pm #2591
My devices are:
AEOTEC Z-Stick Gen5 (Remote)
Devolo Home Control (Thermostat Device)
Do you have shared a list of all supported devices?maart 19, 2016 om 11:59 pm #3003
are you working on a new realease which containts some new devices like the fibaro heat control?
Kind regardsjuli 31, 2016 om 10:03 pm #3651Miss LauraModerator
Aeotec stick should just work.
Devolo home control in the next zwave update.
Below is a list of all devices that are supported now or will be supported in the next update:
Worst case you can add the lines from your device already manually inside PulseStation files and then they should work already now.
Lauradecember 6, 2016 om 9:42 am #3953
after the last update my Devolo heating devices are now supported. At the moment the devices lost their association to the z-Wave stick after 30 seconds. In the first 30 seconds I can sent commands to the devices and they accept it. What can I do to keep the connection up?
- Je moet ingelogd zijn om een reactie op dit onderwerp te kunnen geven.